Hier gehts zur Homepage des neuen Amiga Klon
NatAmi
Und so sehen die Hardware-Spezifikationen aus:
The production of first NatAmi60 developer boards is scheduled for Summer 2008.
Developer NatAmi60 board:
NATAMI with below specification
Including 16 MB high performance Chipmem
68060 CPU (up to 90 MHz for CPU and BUS speed)
256 MB Fastmem
NATAMI Specification:
The Natami is no expansion card but a complete computer, compatible with Commodore AMIGA.
GFX: SuperAGA chipset on board
Compatible to AGA but enhancing it.
Supported Resolutions:
320x256 - 1280x1024
Supported Pixelformats:
Planar 1-8 Planes, HAM 6/8, 8bit Chunky, 16bit Hicolor, 32bit Truecolor
Video and VGA:
31kHz VGA:
Analog VGA SUB-D HD15 output
15kHz screens are automatically scandoubled (not flickerfixed)
SVideo:
PAL/NTSC video output through SVideo connector.
15kHz are shown directly without conversion (SVideo quality).
All screens are scaled to 720x512 (or 720x400 on NTSC) as long as the VSYNC is 50/60Hz
corresponding RGB-analog signals may be available on internal (on board) connector.
Genlock:
an SVideo input connector is available also. The background color can be exchanged with this signal.
This feature is not implementey yet and has lower priority.
AUDIO: Paula style sound
4 Voices
From: 8bit Samples x 6 Volume
To: 16bit Samples x 8 Volume
COPPER: including original AGA copper
BLITTER:
Fully compatible with AGA-AMIGA
Speed of SuperBlitter is many times faster than AMIGA AGA blitter
comparisons will follow.
2D Enhancements:
In Chunky/Hicolor/ or Truecolor pixel mode the Super Blitter can "cookie cut" copy bobs.
Like the AMIGA Sprites, a "cookie cut" copy needs no blitting mask.
This enabled the blitter to use less memory and to work at double speed compared to planar blits.
3D Accelerator:
Texturemapping Blitter enhancement.
Provides Mipmapping, Subpixel 4 way interpolation, Light sources, Antialiasing
Amiga backwards Compatible IDE controller supporting PIO and DMA
Amiga Compatible Floppy Disk controller
2 PCI slots onboard to allow later upgrading (3rd available with riser-caard)
CPU on board
68060 CPU on board for instant compatibility with AMIGA software
CPU expansion slot
Allows upgrade to another CPU (Coldfire/PowerPC/Cell)
SLOT layout will be fully documented to allow 3rd party upgrade designs.